An experienced broadcast engineer's opinion of the potentially looming all digital tests on medium wave. The title says it all and he backs up his opinion:
"Alternate title: Why Medium Wave frequencies do not work for high speed data transmission
Much ink has already been spilled on the merits of HD Radio or lack thereof. The latest NAB sponsored project is the all digital mode test of AM HD Radio. As of this writing, four stations have volunteered to conduct the all digital (no analog) test on their facilities. I predict no great performance improvement in AM HD Radio system will be demonstrated from these tests.
Medium wave is the radio frequencies between 300-3,000 KHz, which is where the Standard Broadcast or AM broadcasting service in the US exists. There are several reasons why trying to make a 20 KHz wide linear digital signal work in those frequencies posses some technical problems:
Electrical noise is very prevalent below 1,000 KHz
Ratio of bandwidth to available frequency is low, therefore low data rates must be used
Narrow bandwidth of existing antenna systems, particularly directional antennas and phasors
Existing uses of the frequencies in question"
Read more at:
http://www.engineeringradio.us/blog...ten-pounds-of-dung-in-a-five-pound-bag-still/
"Alternate title: Why Medium Wave frequencies do not work for high speed data transmission
Much ink has already been spilled on the merits of HD Radio or lack thereof. The latest NAB sponsored project is the all digital mode test of AM HD Radio. As of this writing, four stations have volunteered to conduct the all digital (no analog) test on their facilities. I predict no great performance improvement in AM HD Radio system will be demonstrated from these tests.
Medium wave is the radio frequencies between 300-3,000 KHz, which is where the Standard Broadcast or AM broadcasting service in the US exists. There are several reasons why trying to make a 20 KHz wide linear digital signal work in those frequencies posses some technical problems:
Electrical noise is very prevalent below 1,000 KHz
Ratio of bandwidth to available frequency is low, therefore low data rates must be used
Narrow bandwidth of existing antenna systems, particularly directional antennas and phasors
Existing uses of the frequencies in question"
Read more at:
http://www.engineeringradio.us/blog...ten-pounds-of-dung-in-a-five-pound-bag-still/